Surface Mounted Point Motor (DCC-Fitted) By Gaugemaster | Code: PM20D | N / HO / OO
We guarantee the price of our forthcoming releases for Locomotives, coaches and wagons to be at least 10-25% less than the RRP at the time of release. We also offer large discounts on many of our railway accessory ranges. We continually monitor other retailers to ensure that our prices are always competitive. Please note limited editions and exclusive products are not included in the price promise offer.
Have one to sell? Sell it to Rails of Sheffield
You purchased this item on
|Product category||Point Motor ,|
|Product scale||N / HO / OO|
Designed with easy installation in mind, PM20D is placed parallel to your point-work and operates equally well orientated either way. PM20D works well with all popular modelling scales, and with the leading brands of track in the UK.
The magnetic coils are high-efficiency for reliable operation, needing much less current than most other brands. PM20D also has a plug-in harness that is very easy to use. Mounting screws are included.
Fitting the PM20D is simplicity itself, because the harness is pre-terminated, and the PM20D tie-bar linkage just drops over the point 'tie-bar' pin. PM20D also has manual operation, so you can test it before fixing it down.
If you fix your points directly to the board - You can simply fix the motor directly onto the board with the screws provided after placing the link over the end of the point tie-bar.
If you use track-bed under your points - If the track bed is thin, you may be able to mount PM20 directly, but test first. Otherwise make a pad from card or similarly firm material to raise the PM20D to the correct height before mounting it.
The Digital Decoder - There is a Digital Decoder included in the pack which is fitted with screw terminals for easy connection to a DCC Bus System. The other terminals allow for a manual switch to be added to the circuit and the use of LEDs for route indication. The small switch on the PCB means that programming is as simple as it gets. Just throw the switch to SET, key in an accessory number on your DCC System and flick the switch back to RUN. This PCB is fitted with a sticky pad and screw holes for easy attachment to the base board.
Applying power to PM20D - This product is for low voltage use only, between 16v and 24v (AC or DC are both okay). Please use 1amp supply or greater.
For DCC Layouts you just need to attach two wires from your main DCC Bus into the DCC Terminals on the Decoder. As with all solenoids, this motor is designed for use with passing contact switches such as the GM510 Miniature Toggle Switch. Connection to a standard On-On swich (or a permanent connection or power source) will lead to irreversible damage.
Measurements: Point Motor Length: 68mm Width: 22mm Depth: 9mm Accessory Decoder: Length: 37mm Width: 38mm Depth: 20mm Link Wire: Length: 170mm
- Seep Point Motor with Built-In Switch
- Standard Point Motor Decoder W/CDU
- Surface Mounted Point Motor
- Point Motor Accessory Pack
- Surface Mounted Point Motor (5 Pack)
- Seep Classic Solenoid Point Motor
- Seep Classic Point Motor (5 Pack)
- Classic Solenoid Point Motor (DCC-Fitted)
- Point Motor Decoder W/CDU 4 Way (Twin Pack)
- Seep Point Motor with Latching Mechanism
- Seep Point Motor No Switch
- Point Motor Wire (Red/Green/Black) 10m Tripled (14 x 0.15)
- Standard Point Motor Decoder W/CDU (3 pack)